Olympia Chimney Flue Liner Replacement Nationwide

Olympia Chimney Flue Liner Replacement: The Fort Lauderdale Owner’s Guide

An Olympia Chimney flue liner replacement in Fort Lauderdale typically runs $1,800 to $3,400 installed, and we stock compatible liner on our trucks for most single-story homes. You’ll usually discover the liner has failed during an annual sweep or inspection, when the technician’s camera picks up rust-through, cracking, or separation between liner sections. Some owners notice it first as fine grit falling into the firebox, or a faint smoky smell in the house even with the damper open. Either way, the fix is the same: the old liner comes out, a new one goes in, and you get a written price before we start.

Call (754) 354-1430

We’re an independent chimney service company in Fort Lauderdale, Florida. We’re not affiliated with Olympia Chimney, but we install and stock their liners alongside DuraFlex, HeatShield, and Gelco because we think Olympia makes a solid product for South Florida’s particular conditions.

Which Olympia Chimney Models This Applies To

Olympia Chimney’s flue liners are built to fit their stainless steel chimney systems, and the key spec is inside diameter. Most Fort Lauderdale homes running an Olympia Chimney setup use either a 6-inch, 8-inch, or occasionally 10-inch liner. The quickest way to identify what you have is to check the label plate on the chimney chase or the pipe visible in the attic. If that label is gone, which happens plenty in a humid coastal climate like Fort Lauderdale, we measure the inside diameter on site before quoting anything.

One compatibility gotcha with Olympia Chimney: their liners use a specific locking profile at the seams. A generic liner of the same diameter will not always seat correctly. That’s why we keep genuine Olympia-compatible sections and matched connectors on the truck rather than cutting a competitor’s liner to fit. For older Olympia Chimney systems that are no longer manufactured, we’ll give you a straight answer: if genuine OEM is out of production, a quality aftermarket liner from DuraFlex or Gelco in the correct diameter and gauge is a solid substitute. If it’s not a correct match, we won’t install it. You’re better off knowing that before you pay than after.

Signs Your Olympia Chimney Flue Liner Replacement Is Failing

• Rust flakes or grit in the firebox. In Fort Lauderdale’s salt air and humidity, a liner that’s even slightly compromised pulls moisture, and that moisture eats steel from the inside out. Exterior rust shows up in the firebox as fine metallic grit.
• A smoke smell lingering in the house after a fire. A liner with a crack or separated seam lets smoke into the chimney chase instead of carrying it out the top. That smoke finds its way into wall cavities and back into the living space.
• Visible corrosion on the exposed chimney pipe. Olympia Chimney stainless is good steel, but no stainless is immune to years of Fort Lauderdale salt spray. If the exterior pipe shows pitting, the liner inside is usually further along.
• Drafts that change depending on the day. A liner with a break lets outdoor air enter at the wrong point. Some days the fireplace drafts fine. Others, smoke pushes back into the room for no obvious reason.
• Water stains on the ceiling near the chimney chase. A failed liner lets heat and moisture escape into the chase. In our Florida humidity, that moisture condenses and shows up as ceiling staining long before you see anything in the firebox.

Replacement Cost & What’s Included

A full Olympia Chimney flue liner replacement in Fort Lauderdale typically lands between $1,800 and $3,400 installed. The range comes down to three things: liner diameter, total length from firebox to termination cap, and whether the existing liner was insulated. Insulated liners run higher on materials but hold heat better and last longer in our climate.

Every quote includes the liner sections, connectors, termination cap if needed, labor for the full removal and reinstall, and a camera inspection before and after so you see exactly what we saw. No add-ons at the end. We hand you a written price before any work starts, and that price holds. The work carries our 365-Day Done Right Promise: if the liner fails within one year of install, we come back and make it right at no charge. That’s in writing, on every job.

Here’s the price breakdown for a typical 6-inch Olympia-compatible install:

• 6-inch liner (25 foot): $950 to $1,400
• 8-inch liner (25 foot): $1,100 to $1,700
• 10-inch liner (25 foot): $1,300 to $2,000
• Connectors and termination cap: $180 to $350
• Labor including removal and install: $500 to $850

If your liner failed prematurely, we’ll tell you why. Usually in Fort Lauderdale it’s moisture, not wear. A liner that’s seen ten years of our humidity has lived a harder life than a liner that’s seen twenty in a dry climate.

DIY or Call Us?

A flue liner replacement is not a weekend project. The liner runs the full height of your chimney, which means working from the roof or inside a tight chase, often both. If the liner is damaged mid-run, you’re pulling pieces through a space you can’t fit in. The risk is not just a botched job, it’s a chimney fire you can’t see building inside the wall. This is one of those things where the cheap route costs more.

What you can do safely: look for grit in the firebox, check for visible rust on the exposed pipe, and note any smoke smell after a fire. That’s your diagnostic. We’ll bring the camera, the lifting gear, and the correct Olympia-compatible liner sections. Hank Delano has been running chimney work across South Florida long enough to know that Fort Lauderdale houses each have their own quirks, and he’ll tell you the truth about yours. Call (754) 354-1430 and we’ll set a time that works.

FAQs